24 hours Service Hotline

+86-15612755608

If you have any questions or problems,please feel free to contact us.

           View Contact>>

High-speed Flattening Slitting Cutting Machine

  • Feed back Email:admin@hbhuikeyuan.com
  • Product Overview
  • Technical Parameters

Flattening machine Product description

Flattening machine is commonly used in plate processing equipment, flattening machine finalize the design mainly depends on the strip thickness, material.The thicker material needed to better rigidity structure, and the less the number, and the greater, the greater the power (a certain width), and vice versa.


Application

Flattening machine is mainly applied to correct all kinds of plates and cut into pieces. The device can apply to all kinds of cold and hot rolled plate leveling. Due to its easy operation, simple, range of application in machinery, metallurgy, building materials, chemical industry, electronics, power, light industry and other industries, especially in shipbuilding, locomotive vehicle, bridge, boiler metal structure factory etc, become the indispensable essential product in production.

Please fill in your inquiry form and we will respond to you with in 24 hours.
 
Name *
Tel
Email *
Country
Product Name *
Message content *
 
   
  Note: * number can not be empty
   

Related Products

  • sheet metal profiling machine

    HKY-750 Steel Floor Deck Roll Forming Machine

    ●HKY-750 Steel Floor Deck Roll Forming Machine Product description: HKY-750 Steel Floor Deck Roll Forming Machine production products building bearing plate (steel bearing plate, building of profiled steel sheet) is the use of galvanized steel plate after rolling and cold bending moulding. The section into V-shaped, U-shaped, trapezoidal or waveforms are similar to the several forms of, mainly used as permanent formwork, can also be selected for other purposes.   750 floor board machine production of steel building bearing plate shape simple, wave of large, high strength, after the installation of spot welding steel reinforced concrete site, with good adhesion. In the high-rise building can not only save steel formwork and can reduce the floor load, in order to achieve the same capacity under the premise, so that the amount of steel construction is reduced, thereby saving investment.   Floor 750 bearing plate molding equipment production of the product appearance, reason...

  • corrugated sheet metal machine

    HKY-915 Floor Deck Roll Metal Forming Floor Tile Making Machine

    ●HKY-915 Floor Deck Roll Metal Forming Floor Tile Making Machine Product description: HKY-915 Floor Deck Roll Metal Forming Floor Tile Making Machine to meet the requirements of the main steel structure of the rapid construction, can provide a firm operating platform in a short period of time, and can be used to lay the pressure type steel plate, layered pouring concrete slab of water. The use of advanced hydraulic drive, automatic cut off after forming, no deformation, no waste, higher safety factor (the main engine shutdown).

  • Various Punching Plates

    Various Punching Plates/Block Dies

    ●Various Punching Plates/Block Dies Product description: Pattern and block dies punching machine is installed on the shaft end gear set, dial pin gear transmission, toggle mounted on the six-party turn sheave on the shaft to implement dividing positioning, on the shaft at each end is equipped with a and installed on the same shaft and suppression of conjugate CAM to CAM, lower die are implemented by locating rod and the positioning plate in the precise localization of work position. Within the left and right sides of the case, install a lubrication pump, machine work, the tubing to the movement of friction parts lubricating oil.

  • steel floor decking roll forming machine

    HKY-600 Floor Decking Metal Roll Forming Machine

    ●HKY-600 Floor Decking Metal Roll Forming Machine Product description: HKY-600 Floor Decking Metal Roll Forming Machine for floor panels, high strength, good adhesion. In the high-rise building can save steel template and can reduce the floor bearing, under the premise of attaining the same capacity, so that the project to reduce the amount of steel, subsequently saving cost.